Toshiba e-STUDIO2010AC Imaging Manual page 67

(7) Select [05 ADJUSTMENT MODE]. Change the values for codes [7889 to 7892] to adjust the
maximum color density of the text.
Color to
[05] code
adjust
05-7889 Set a value larger than 5 to
Y (Yellow)
M (Magenta) 05-7890
C (Cyan) 05-7891
K (Black) 05-7892
• Set the value in increments of 1, while checking the copy image until the optimum value is
obtained.
• This adjustment will be effective, only if the [Text/Photo] or [Text] mode is selected or the [Custom]
mode based on the [Text/Photo] or [Text] mode is selected from among the original mode options.
Only the text areas (portions that are recognized as text) are adjusted in the [Text/Photo] mode
and [Text] mode. Only K color can be adjusted in the [Text] mode.
After adjusting the maximum color density of the text, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(8) Press [Basic] tab on the Copy mode. Select "Text" from among the original mode options.
• To have [Text] selected from among the original mode options by default, perform the following
setting.
Press [User Functions -User-] and select [Copy] in the [User] tab. Select [Text] in the "Original
Mode for Color" option.
After changing the value, make a copy and check the image quality.
If further image quality adjustments are necessary, reset all the values changed in steps (1) to (7)
above to the default one and then follow the next step.
(9) Select [08 SETTING MODE]. Change the value for code [2548] to make the outline of the copied
text thicker and clearer, or thinner and finer.
• This adjustment can be made applicable to all colors by selecting the corresponding subcode.
However, it is recommended to enter the same setting value for all the subcodes unless otherwise
required.
Setting item
Potential on
M
printing white text /
Correction setting
• To check the amount changed with this setting, it is recommended to set the value at "3" or "4" first
to decrease it, and then to set the value at "8" or "9" first to increase it. Then check the copy image
and increase or decrease the value further so that the image will be adjusted finely.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Recommended value
increase the density.
Set a value smaller than 5
to decrease the density.
[08] code Subcode
Y 0
1
08-2548
C 2
K 3
2-13
Acceptable
Default
value range
0 to 10 5
Recommended value
To make the outline of text
thicker and clearer:
Set a value smaller than 6.
To make the outline of text
thinner and finer:
Set a value larger than 6.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2.Copier-specific Adjustments
Acceptable
Default
range value
0 to 12 6