Toshiba e-STUDIO2010AC Imaging Manual page 107

(5) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7840], [7841] and [7842] to
adjust the reproduction level for the Text/photo, User Custom and Red Seal Color original modes.
Color mode Original mode
Text/Photo
Full color User Custom
Red Seal Color
• Adjustment for the User Custom setting is enabled in the Text/photo mode base only.
• Set the value in increments of 1, while checking the copy image until the optimum value is
obtained.
Set the value to "5" and check the copy image quality.
If further image quality adjustment is necessary, set the value to "4".
If further adjustment is necessary, decrease the value step by step.
• Remember that if a value larger than "5" is set, the edges of the image are enhanced (attaching
importance to the reproducibility of text). The table below shows you the correlation between the
value and image quality.
Value
0 Default
Intended to improve the reproducibility of photos
1
more than the one obtained when "2" is set.
Intended to improve the reproducibility of photos
2
more than the one obtained when "3" is set.
Intended to improve the reproducibility of photos
3
more than the one obtained when "4" is set.
Intended to improve the reproducibility of photos
4
more than the one obtained when "5" is set.
Equivalent to the one obtained when the default
5
value ("0") is set.
Intended to improve the reproducibility of text more
6
than the one obtained when "5" is set.
Intended to improve the reproducibility of text more
7
than the one obtained when "6" is set.
Intended to improve the reproducibility of text more
8
than the one obtained when "7" is set.
Intended to improve the reproducibility of text more
9
than the one obtained when "8" is set.
• For the User Custom mode, refer to "2.19 To Program Frequently Used Copy Settings (To use
Custom Mode)".
 Caution after the adjustment
When an original containing text is copied, the adjustment may possibly cause the text to become
blurred on the copy. Therefore, carefully perform the adjustment, while checking the copy image.
 Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may
cause a loss in MFP performance, including degradation in the image quality.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
[05] code Recommended value
05-7840
Set a value smaller than
05-7841
05-7842
Advantage of image quality
2-53
2.Copier-specific Adjustments
Acceptable
value range
0 to 9
5.
Reproducibility of edges
Intermediate
Intermediate
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Default
0
Soft






Sharp