Toshiba e-STUDIO2010AC Imaging Manual page 112

2.Copier-specific Adjustments
(4) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7960], [7961], [7965],
[7966], [7970], [7971], [7975], [7976] and [7980] to [7983] to adjust the density for each color.
Original Color to
mode adjust
Y (Yellow)
M (Magenta)
Text/Photo
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta)
Text
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta)
User Custom
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta)
Red Seal
Color
C (Cyan)
K (Black)
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
• The setting value "25" corresponds to one step in the adjustment on the control panel.
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted.
Subcode
0
1
2
 Caution after the adjustment
The adjustment may possibly cause a dark-colored area, such as in a photo, to become blurred on the
copy. Also, it may also cause offset failure, grained images and degradation in gradation. Therefore,
carefully perform the adjustment, while checking the copy image.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
[05] code Subcode
05-7960 0/1/2
05-7965 0/1/2
05-7970 0/1/2
05-7975 0/1/2
05-7961 0/1/2
05-7966 0/1/2
05-7971 0/1/2
05-7976 0/1/2
05-7980 0/1/2
05-7981 0/1/2
05-7982 0/1/2
05-7983 0/1/2
05-7984 0/1/2
05-7985 0/1/2
05-7986 0/1/2
05-7987 0/1/2
Area where the density is adjusted
Low density area
Middle density area
High density area
2-58
Recommended Acceptable
value value range
Set a value larger
than 128.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Default
0 to 255 128