Toshiba e-STUDIO2010AC Imaging Manual page 62

2.Copier-specific Adjustments
(9) Select [08 SETTING MODE]. Change the value for subcode 3 of code [2548] to make the outline of
the copied text thicker and clearer, or thinner and finer.
• This adjustment can be made applicable to all colors by selecting the corresponding subcode. In
this step, however, change the setting value only for subcode 3 to adjust the image quality for the
black mode.
Setting item
Potential on printing
white text / Correction
setting (K)
• To check the amount changed with this setting, it is recommended to set the value at "3" or "4" first
to decrease it, and then to set the value at "8" or "9" first to increase it. Then check the copy image
and increase or decrease the value further so that the image will be adjusted finely.
• After changing the value, perform automatic calibration.
Refer to step (1) in "1.1 To Obtain a Darker Image" to perform automatic calibration.
If further adjustments are necessary after performing step (9), you can repeat steps (1) to (8). When
repeating these steps, however, adjust the value while checking the copy image carefully.
(10) Select [08 SETTING MODE]. Change the value for subcode 3 or 7 of code [2620].
• This adjustment is available only for e-STUDIO2010AC.
• This adjustment also influences the printing and fax functions as well as the copying function.
Original mode
Text/Photo
Plain paper
Text
Thick paper
Recycled
Photo
paper
Image
Thin paper
smoothing
Text/Photo Thick paper
1/2/3/4
Text
Special paper
Photo
1/2/3
Envelope
Image
Transparency
smoothing
(OHP film)
 Caution after the adjustment
The adjustment may possibly cause an increase in the amount of toner used, moiré, blurred text (small,
dark text blurred), faint text (fine outlines of text shredded) diminished photo images or gradational
images (less accurate reproducibility of halftones), or in some consumption conditions of consumables,
background fogging or a decrease in the amount of developer material (carrier streaks). Therefore,
carefully perform the adjustment while checking the copy image.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
[08] code Subcode
To make the outline of text
thicker and clearer:
Set a value smaller than 5.
08-2548 3
To make the outline of text
thinner and finer:
Set a value larger than 5.
[08]code Subcode
08-2620 3
08-2620 7
2-8
Recommended value
Recommended Acceptable
value range value
Set a value larger
than 15 to make the
text darker and
clearer.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Acceptable
Default
range value
0 to 12 6
Default
8 to 36 15