Toshiba e-STUDIO2010AC Imaging Manual page 119

• Set the value in increments of approximately 4, while checking the copy image until the optimum
value is obtained.
• Although the larger the value, the darker the density becomes, offsetting may occur if the value is
too large. Adjust the value while checking the copy image carefully.
• The table below shows you the acceptable paper weight for the paper type.
Paper type
Thick paper
Thick paper 1
Thick paper 2
Thick paper 3
Thick paper 4
• Use the recommended OHP transparencies and special paper 1 and 2.
After adjusting the amount of toner used, copy and check the copy image quality.
If further image quality adjustments are still necessary, the service technician must perform the next
procedure.
(3) Perform color balance adjustment or RGB adjustment to adjust the tint of the colors in general.
For further information regarding the adjustment procedures, refer to procedure (3) in "2.3 To
Closely Match the Color Balance of the Original".
After adjusting the tint of colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Acceptable paper weight
81 to 105 g/m²
106 to 163 g/m²
164 to 209 g/m²
210 to 256 g/m²
257 to 280 g/m²
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-65
2.Copier-specific Adjustments
22 to 28 lb. Bond
Max. 60 lb. Cover
Max. 110 lb. Index
Max. 140 lb. Index
Max. 100 lb. Cover