8
10.04
112325
Explanation
Response
Remedy
112326
Explanation
Response
Remedy
112327
Explanation
Response
Remedy
112328
Explanation
Response
Remedy
112329
Explanation
Response
Remedy
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Replace swivel head
The operator is prompted to replace the specified swivel head in the
spindle with the new swivel head.
Alarm display
Please refer to the machine manufacturer's instructions.
Exchange swivel head.
Please refer to the machine manufacturer's instructions.
Set swivel head
The operator is prompted to set the swivel head in accordance with
the specified data.
Alarm display
Please refer to the machine manufacturer's instructions.
Set swivel head.
Please refer to the machine manufacturer's instructions.
Angle outside the permissible range
The programmed machining operation cannot be performed with the
inclinable head.
Alarm display
Perform NC reset.
Clamp the workpiece differently if appropriate.
Angle adapted to angle grid
Due to the angle grid, the swivel head could not be set exactly to the
specified angle.
Alarm display
Machining can be continued with the specified values, but it will not
correspond exactly to the programming.
Set swivel head/table
The operator is prompted to set the swivel head/table in accordance
with the specified data.
Alarm display
Please refer to the machine manufacturer's instructions.
Set swivel head/table.
Please refer to the machine manufacturer's instructions.
Alarms and Messages
8.2 Alarms in ShopMill
8
8-409