2
10.04
2.10.7 Overstore
Overstore with single
block
Single Block
Cycle Start
Overstore without single
block
Cycle Stop
Cycle Start
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
In "Machine Auto" mode you can overstore technological parameters
(auxiliary functions, programmable instructions, etc.) in the working
memory of the NC. You can also enter and execute any NC block.
Overstore does not alter the programs stored in the part program
memory.
Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Press the "Single Block" key to execute the program block by
block.
The program automatically stops at the next block boundary.
Press the "Overstore" softkey.
The "Overstore" window opens.
Enter the NC blocks to be processed.
Press the "Cycle Start" key.
The blocks you have entered are stored. You can observe execution
in the "Overstore" window.
After "Overstore", a subroutine with the content REPOSA, which you
can observe, is executed.
Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Press the "Cycle Stop" key.
Press the "Overstore" softkey.
The "Overstore" window opens.
Enter the NC blocks to be processed.
Press the "Cycle Start" key.
Operation
2.10 Automatic mode
2
2-127