3
10.04
3.8.8 Use of position patterns for milling
Select with softkey
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
If you want to mill a pocket, spigot or longitudinal slot at more than
one position, you must program a separate positioning block. When
you call the milling cycle, use softkey "Alternat." to select "Pos.
pattern" in the "Single position" parameter field. The parameters for
single positions X0, Y0 and Z0 then disappear from the display.
Extract from the parameter form of a rectangular pocket with "Pos. pattern" entry
After you have finished programming the cycle and stored it, you need
to program the position pattern.
Positions >
ShopMill automatically chains the milling cycle and the subsequently
programmed position pattern.
Programming with ShopMill
3.8 Milling
3
3-283