Siemens SINUMERIK 840D Operation/Programming Manual page 124

2
Operation
2.10 Automatic mode
Search
pointer
To External -
endpoint without cal.
...
Cycle Start
Cycle Start
Reset
Search
Search
Continue
search
Start
search run
2-124
Specify target directly
Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Press the "Block search" and "Search pointer" softkeys.
Specify the desired target.
Select a calculation technique.
Press the "Cycle Start" key.
ShopMill carries out all necessary default settings.
Press the "Cycle Start" key again.
The new starting position is approached. The program executes from
the beginning or end of the target block, depending on the calculation
technique.
You can abort the search by pressing the "Reset" key.
Search for any text
Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Press the "Block search" and "Search" softkeys.
Enter the text string that you want to locate.
Select whether the search is to commence at the start of the
program or the current cursor position.
Press the "Search" softkey.
The program block that contains the text string is marked.
Press the "Continue search" softkey, if you want to continue the
search.
Press the "Abort" and "Start search run" softkeys.
Where chained program blocks have several technology blocks,
select the desired technology block in the "Search run" window
and press the "Accept" softkey.
The prompt does not appear in the case of single program blocks.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
2
10.04
 Siemens AG, 2004. All rights reserved