Description Of The Alarms - Siemens SINUMERIK 840D Operation/Programming Manual

8
Alarms and Messages
8.2 Alarms in ShopMill

8.2.3 Description of the alarms

112100
Explanation
Response
Remedy
112200
Explanation
Response
Remedy
112201
Explanation
Response
Remedy
8-406
Renumbering error.
Initial state restored.
You have selected the "Renumber" softkey in the program editor. An
error during renumbering has damaged the program in the memory.
The initial program must now be reloaded to the memory.
Alarm display
Program has not been renumbered.
Create space in the memory, e.g. by deleting an old program. Select
"Renumber" softkey again.
Contour is step in current program sequence. Processing not
enabled
The selected contour is an element of the program loaded under
"Program".
Alarm display
The contour is an element from a loaded program and cannot be
deleted or renamed.
Remove contour from the loaded program.
Contour is step in current Automatic sequence. Processing not
enabled
The selected contour is an element of the program loaded under
"Machine Auto".
Alarm display
The contour is an element of a program loaded under "Machine Auto"
and cannot be deleted or renamed. After program start, contours
included in the current program cannot be altered under "Program"
while the program is running.
Stop program run and load program under "Program". Delete contour
from program.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
8
10.04
 Siemens AG, 2004. All rights reserved