Siemens SINUMERIK 840D Operation/Programming Manual page 324

4
Programming with G Code
4.3 G code editor
Selecting G code
Mark
Copying G code
Copy
Pasting G code
Insert
Cutting G code
Cut
4-324
The G code editor will be opened automatically if you write or open a
G code program.
Place the cursor at the position in the program where you want
your selection to start.
Press the "Mark" softkey.
Place the cursor at the position in the program where you want
your selection to end.
The G code is selected.
Select the G code that you want to copy.
Press the "Copy" softkey.
The G code is stored in buffer memory and remains there even if you
switch to another program.
Copy the G code that you want to insert.
Press the "Insert" softkey.
The copied G code is pasted from buffer memory into the text in front
of the cursor.
Select the G code that you want to cut.
Press the "Cut" softkey.
The selected G code is removed and stored in buffer memory.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
4
10.04
 Siemens AG, 2004. All rights reserved