Siemens SINUMERIK 840D Operation/Programming Manual page 325

4
10.04
Finding G code
Search
>
Continue
search
Finding and replacing G
code
Search
>
Search/
Replace
Replace
all
Find next
Replace
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Press the "Search" softkey.
A new vertical softkey bar appears.
Enter the character string that you want to locate.
Press the "OK" softkey.
The G code program is searched for the character string in the
forward direction. The character string is marked in the editor by the
cursor.
Press the "Find next" softkey if you want to continue the search.
The next character string found is displayed.
Press the "Search" softkey.
A new vertical softkey bar appears.
Press the "Search/Replace" softkey.
Enter the character string that you want to find and the characters
that you want to insert in its place.
Press the "OK" softkey.
The G code program is searched for the character string in the
forward direction. The character string is marked in the editor by the
cursor.
Press the "Replace all" softkey if you want to replace the
character string throughout the entire G code program.
-or-
Press the "Find next" softkey if you want to continue the search
without replacing the instance of the character string found.
-or-
Press the "Replace" softkey if you want to replace the character
string at this point in the G code program.
Programming with G Code
4.3 G code editor
4
4-325