4
Programming with G Code
4.3 G code editor
Jumping to start/end
Continue
>
To
To
start
end
Renumber the G code
blocks
Continue
Re-
>
number >
4-326
Select the "Continue" and "To start" or "To end" softkeys.
The beginning or end of the G code program is displayed.
Select the "Continue" and "Renumber" softkeys.
Enter the number of the first block and the increment between
block numbers (e.g. 1, 5, 10).
Press the "Accept" softkey.
The blocks are renumbered.
You can cancel the numbering again by entering 0 for the increment
or block number.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
4
10.04
Siemens AG, 2004. All rights reserved