Milling A Contour Pocket - Cycle63 - Siemens SINUMERIK 840D sl Programming Manual

No. Param Param
mask internal
14 _UMODE
_GMODE
15
25 _DMODE
26 _AMODE
18.1.29

Milling a contour pocket - CYCLE63

Programming
CYCLE63(STRING[100] _PRG, INT _VARI, REAL _RP, REAL _Z0, REAL _SC,
REAL _Z1, REAL _F, REAL _FZ, REAL _DXY, REAL _DZ, REAL _UXY, REAL
_UZ, INT _CDIR, REAL _XS, REAL _YS, REAL _ER, REAL _EP, REAL _EW,
REAL _FS, REAL _ZFS, STRING[20] _TR, INT _DR, INT _UMODE, INT
_GMODE, INT _DMODE, INT _AMODE)
Parameters
No. Param Param
mask internal
1 PRG _PRG
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Explanation
Reserved
Mode for evaluation of programmed geometrical data
UNITS: Reserved
TENS: Reserved
HUNDREDS: Select machining/only calculation of start point
0 = Normal machining (no compatibility mode needed)
1 = Normal machining
2 = Reserved
Display mode
UNITS: Machining plane G17/18/19
0 = Compatibility, the plane effective before cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
TENS: Technology mode
1 = Predrilling
2 = Centering
Alternative mode
UNITS: Drilling/centering depth Z1
0 = Absolute (compatibility mode)
1 = Incremental
TENS: Units for plane infeed (_DXY)
0 = mm
1 = % of tool diameter
Explanation
Name of removal program
Programming cycles externally
18.1 Technology cycles
689