Siemens SINUMERIK 840D sl Programming Manual page 462

Path traversing behavior
10.3 Acceleration behavior
Syntax
Activate dynamic values:
DYNNORM
DYNPOS
DYNROUGH
DYNSEMIFIN
DYNFINISH
Note
The dynamic values are already active in the block in which the associated G command is
programmed. Machining is not stopped.
Read or write a specific field element:
R<m>=$MA...[n,X]
$MA...[n,X]=<value>
Meaning
DYNNORM
DYNPOS
DYNROUGH
DYNSEMIFIN
DYNFINISH
R<m>
$MA...[n,X]
<n>
<X>
<value>
462
: G command for activating normal dynamic response
: G command for activating the dynamic response for positioning mode,
tapping
: G command for activating the dynamic response for roughing
: G command for activating the dynamic response for finishing
: G command for activating the dynamic response for smooth-finishing
: R-parameter with number
: Machine data with field element affecting dynamic response
: Array index
Range of values: 0 ... 4
0
1
2
3
4
: Axis address
: Dynamic value
<m>
Normal dynamic response (
Dynamic response for positioning mode (
Dynamic response for roughing (
Dynamic response for finishing (
Dynamic response for smooth-finishing (
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
)
DYNNORM
)
DYNPOS
)
DYNROUGH
)
DYNSEMIFIN
DYNFINISH
)
Job Planning