8 Tool Management
8.10
Configuring the operator interface
8.10.4
Adapting individual parameters
Magazine location
type
Example
8-116
Using the configuration file to_mill.ini, you can change the default settings for
specific tool parameters.
Table 8-9
PARAMETER_IDENTIFIER
PARAMETER_IDENTIFIER
T_MAG_PLACE_TYPE
TPC1
TPC2
TPC3
TPC4
TPC5
TPC6
TPC7
TPC8
TPC9
TPC10
You can change the input field into a toggle field for the parameter "Magazine
location type". The following values are entered: You must define the values of
the toggle field in the section T_MAG_PLACE_TYPE, by assigning values to
cursor texts.
Value = Text–ID
Valid Text–IDs and information on defining texts are provided in Chapter 8.10.7
"Defining texts").
[T_MAG_PLACE_TYPE]
DEFAULT = 89891
1 = 89868
2 = 89869
5 = 89872
9 = 89876
In this example, in the column "location type" you can select the values 1, 2, 5
or 9 using the "alternative" softkeys. Here, the values have been randomly se-
lected. Cursor texts that have been saved are displayed for the selected values.
If the actual value of the parameter devices from the configured values, then the
text, saved as DEFAULT, is displayed as cursor text.
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
parameters
Magazine location type
Parameter 1
Parameter 2
Parameter 3
Parameter 4
Parameter 5
Parameter 6
Parameter 7
Parameter 8
Parameter 9
Parameter 10
© Siemens AG 2006 All Rights Reserved
11/2006