Siemens SINUMERIK 840DE sl Commissioning Manual page 85

11/2006
Search strategy
$TC_MAMP2
Location type
$TC_MPP1
Location type
$TC_MPP2
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
$TC_MAMP2= Type of search strategy
This mask is divided into a right and left byte.
S
The right byte describes the tool search (bits 0 and 1).
S
and the left byte describes the empty location search for the spindle tool.
A value must be specified for both strategies.
Bit mask (specification applies for bit=1):
S
Bit 0: Search for active tool with tool designation (1)
S
Bit 1: Search for next tool with tool designation (2)
S
Bit 8: Search from 1st location onwards (256)
S
Bit 9: Search from current location onwards (512)
S
Bit 10: Search from last location backwards (1024)
S
Bit 11: Search from current location backwards (2048)
S
Bit 12: Search from current location symmetrically (4096)
Example $TC_MAMP2=4097 (bit 12 and bit 0=1)
Bit 12: Search for empty location: search from current location symmetrically,
Bit 0: Tool search: Search for active tool
$TC_MPP1[MagazineNo, LocNo]= Type of location:
S
1 = magazine location
S
2 = spindle
S
3 = gripper
S
4 = loader
S
5 = transfer location
S
6 = loading station
S
7 = loading point
Default: value of corresponding location type
$TC_MPP2[MagazineNo, LocNo]= Type of location:
Any values can be entered here. The values must match the tools to be loaded
at the location.
Buffers and loading points have the value 0!
8 Tool Management
8.3 Startup in NCK
8-85