Supplementary Conditions - Siemens SINUMERIK 840DE sl Commissioning Manual

Supplementary Conditions

© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Please observe the following supplementary conditions when using ShopMill:
S
ShopMill is only executed in channel 1, mode group 1.
S
Up to 5 axes plus a spindle are displayed on the ShopMill operator interface.
S
The machine axes are assigned to fixed numbers (1=X, 2=Y, 3=Z).
S
The spindle can be assigned to axis numbers 4, 5 or 6.
S
ShopMill allows for a geometry axis interchange under the following pre-
conditions.
Three geometry axes must always be present.
The names of the channel axes (MD 20080) and the geometry axes
(MD 20060) must be uniquely different.
A geometry axis interchange can only be programmed for linear axes.
A geometry axis interchange does not exist for spindles.
Only ShopMill–approved add–on axes may be exchanged with geometry
axes.
S
ShopMill operates only with tool management.
Spindle 1 must always be the change point (see configuration file). The load
point can be 1 or 2 (see MD 9673 $MM_CMM_TOOL_LOAD_STATION).
S
With ShopMill Open you are not allowed to change the position of the follow-
ing softkeys. This means that a specific task must always be assigned to
these functions in the REGIE.INI file.
Task 0 (horizontal softkey 1): Operating area – Machine
Task 1 (horizontal softkey 2): Operating area – Program manager
Task 2 (horizontal softkey 3): Operating area – Program
Task 4 (horizontal softkey 5): Operating area – Tools/Zero offsets
S
Several operator panels can be used for ShopMill via TCU.
S
The HMI and Windows screen savers must not be used at the same time.
References: /IHE/, Commissioning Manual CNC: Basic software and
HMI Embedded, SINUMERIK 840D sl,
/IAM/, Commissioning Manual CNC: Basic software and
HMI Advanced, SINUMERIK 840D sl/840D/840Di/810,
IM2sl Commissioning HMI Embedded
IM4 Commissioning HMI Advanced
2
2-13