11/2006
4.2
Initial start–up
4.2.1
Sequence
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Before you begin startup please read the general conditions and reserved functions.
For installation and startup proceed as follows:
1. ShopMill installation on PCU (for ShopMill on PCU 50.3 only).
For ShopMill on NCU (HMI Embedded), the ShopMill software is pre–
installed.
2. PLC commissioning
3. NCK commissioning
4. Install additional functions (optional)
5. Adapt display machine data
6. Customize the operator interface (optional)
7. Run a test using the acceptance certificate
You can start up tool management either together with NCK and PLC startup or
afterwards. If tool management is already set up on the machine you only need
to adapt the display machine data for tool management; (see Section 8.2
"Startup sequence").
You can find a detailed description of the start–up process in the following docu-
mentation:
References:
/IDsl/, Commissioning Manual CNC: NCK, PLC,
drives, SINUMERIK 840D sl,
/IHE/, Commissioning Manual CNC: Basic software and
HMI Embedded, SINUMERIK 840D sl,
/IAM/, Commissioning Manual CNC: Basic software and
HMI Advanced, SINUMERIK 840D sl/840D/840Di sl/810D
4 Commissioning
4.2
IM2 Commissioning HMI Embedded,
IM4 Commissioning HMI Advanced
Initial start–up
4-19