Sony MSB-2000 Operation Manual page 83

Multi-format stream bridge
Table of Contents

Advertisement

List of Menus
Item number Category
T052
status
T053
status
T054
status
T055
status
Item
Arguments
rtp_rx_error
rtp_rx_ssrc_no
rtcp_rx_cname
rtp_tx
Function
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, when fec_mode is "on," outputs the
total number of TS packets for which FEC
correction was not possible from the start
of receiving (when proc start is submitted)
until the command is submitted.
The maximum output value is "255." That
is to say, when there are a total of 255 or
more TS packet for which FEC correction
was not possible, the output is "255."
This status value only is reset to zero when
proc start is submitted.
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, outputs the SSRC value of the
RTCP packet currently being received.
In sdi_to_asi/sdti-cp_to_asi mode, "--------"
is output.
If no RTCP packets are received, "--------"
is output.
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, outputs the CNAME field value of
the RTCP SDES packet currently being
received.
The output format is ASCII printable
characters (0x21≤x≤0x7d), with a
maximum of 15 characters, left aligned.
In sdi_to_asi/sdti-cp_to_asi mode, "--------"
is output.
If no RTCP packets are received, "--------"
is output.
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In sdi_to_asi/sdti-cp_to_asi/tx-rx/tx-rx (cm)
mode, outputs the RTP packet
transmission status.
In asi_to_sdi/asi_to_sdti-cp mode, outputs
"--------" to indicate that this is invalid.
If the rtp_tx command is "off," "off" is
output.
If rtp_tx is "on," but for any reason
transmission to the network is stopped,
"halt" is output.
If rtp_tx is "on," and RTP packets are being
transmitted to the network, "running" is
output.
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
83

Advertisement

Table of Contents
loading

Table of Contents