Sony MSB-2000 Operation Manual page 60

List of Menus
(In sdti-cp_to_asi mode)
Item number Category
C027 setup
C028 setup
C061 setup
C062 setup
C063 setup
C064 setup
C065 setup
C066 setup
C067 setup
C068 setup
C069 setup
C070 setup
C071 setup
C072 setup
C073 setup
C074* setup
C075 setup
C076 setup
Item Arguments
lpcm_word_len 16
20
24
tx_audio_sg off
1 kHz
silence
ts_rate auto
manual
3.000 to 8.448 to 68.000 1 kbps. If a certain degree of error occurs,
tx_program_no 00001 to 00200 to 65535 Specifies the program number declared in
video_pid 0×0010 to 00ff to 1ffe
mpeg_ch12_pid 0×0010 to 0101 to 1ffe
mpeg_ch34_pid 0×0010 to 0102 to 1ffe
lpcm_pid 0×0010 to 0100 to 1ffe
pat_version 0 to 31
pat_interval 1 to 33 to 100
pmt_version 0 to 31
pmt_interval 1 to 33 to 100
pcr_pid 0×0010 to 00fe to 1ffe
pcr_interval 1 to 33 to 100
program_map_pid 0×0010 to 00c8 to 1ffe
network_pid 0×0010 to 0064 to 1ffe
tx_packet_size 188
204
tx_asi_mode packet
burst
Function
Sets the linear PCM sample word length to
16 bits.
Sets the linear PCM sample word length to
20 bits.
Sets the linear PCM sample word length to
24 bits.
Disables the internal test signal generator.
Enables the internal test signal generator
to output a 1 kHz sine wave.
Enables the internal test signal generator
to output silence.
The TS rate is calculated automatically. An
'A' appears after the numeric value.
The TS rate can be specified in units of
this is controlled to be below the setting
value.
Argument unit :Mbps
Note
When the MSBA-20IP is installed, keep
ts_rate within 35.000 Mbps.
PAT.
Specifies the video PID.
Specifies the PID for MPEG audio
channels 1 and 2.
Specifies the PID for MPEG audio
channels 3 and 4.
Specifies the PID for linear PCM audio.
Specifies the PAT version number.
Sets the PAT generation interval.
Unit: 1 ms
Specifies the PMT version number.
Sets the PMT generation interval.
Unit: 1 ms
Specifies the PID for PCR.
Sets the PCR generation interval.
Unit: ms
Specifies the PID for PMT.
Specifies the PID for NIT.
Specifies the output TS packet size as 188
bytes.
Specifies the output TS packet size as 204
bytes.
(16 bytes of dummy data inlucluded.)
Note
When an MSBA-20IP board is installed,
the TS packet size for an MPEG stream
output through RTP is fixed at 188 bytes,
irrespective of this setting.
Outputs output TS in packet mode.
Outputs output TS in burst mode.
60