Away/Stay 1 Arm/Disarm - Bosch Solution 2000 Installation Manual

50 en | System Functions
Sequence
1
2
3
4
5
Each event is indicated by a beep every 2 second and a lit indicator. You can also press [STAY]
key to review the previous event.
After the last event, three beeps sound to indicate the end of playback. You can stop the
replay at any time by pressing [AWAY].
When working with a text codepad, the events are played back automatically after entered
event memory recall mode. And you can also page up or page down manually to review the
events. You can stop the replay at any time by pressing [AWAY].
Notice!
If the system is armed in STAY Mode 1 or STAY Mode 2, the STAY indicator shows the event
memory playback. There is no differentiation between STAY Mode 1 and STAY Mode 2.
If the control panel is powered down, the memory of all events is saved.
7.1.11

AWAY/STAY 1 Arm/Disarm

This function allows you to arm/disarm the system in AWAY mode or in STAY 1 mode with the
installer code.
To arm the system in AWAY mode:
1.
2.
To disarm the system from AWAY Mode:
1.
2.
To arm the system in STAY Mode 1:
1.
2.
To disarm the system from STAY Mode 1:
1.
2.
2017.10 | 03 | F.01U.298.026
Indicator On
2 , ,
1 ,
4 ,
3 ,
2 , ,
Enter the Installer Code and press [9][AWAY].
Two beeps sound, the AWAY indicator lights, and Exit Time starts.
Enter the Installer Code and press [9][AWAY].
Two beeps sound and the AWAY indicator is extinguished.
Enter the Installer Code and press [9][STAY].
Two beeps sound and the STAY indicator is lit. Exit Time starts.
Enter the Installer Code and press [9][STAY].
Two beeps sound and the STAY indicator is extinguished. The system is now disarmed.
Event
Stay armed by User 2
Disarmed by User 1
Alarm in Zone 4
Alarm in Zone 3
AWAY armed by User 2
Installation Guide
Control Panel
Bosch Security Systems, Inc.