Installation Workflow - Bosch Solution 2000 Installation Manual

Control Panel
3

Installation workflow

Before installing and operating the control panel, read these instructions. Failure to follow
these procedures may cause the device not to function properly. Bosch Security Systems Inc.
is not responsible for any devices that are improperly installed, tested, or maintained.
This document does not contain special information about local requirements and safety
issues. Information on such issues is provided only to the extent that it is needed for
operation of the device. Ensure that you are familiar with all safety-related processes and
regulations in your area. This also includes how to act in the event of an alarm and the initial
steps to take if a fire breaks out. The operating instructions should always be available on site.
It is a required part of the system and must be given to the new owner if the system is ever
sold.
Use the workflow and checkboxes below as you complete steps.
See also
–
–
–
–
–
–
–
–
–
Bosch Security Systems, Inc.
Install the enclosure
Install the control panel
Install and wire for telephone communication
Install and wire for IP communications
Install and wire the transformer
Install and wire arming devices
Install and wire outputs
Install and wire inputs
Complete the installation
Install the transformer, page 24
Communication Information, page 68
B426/B426-M Conettix Ethernet Communication Modules, page 21
B450/B450-M Conettix Plug-in Communicator Interfaces, page 21
Codepads, page 14
RADION keyfobs, page 19
Keyswitches, page 23
WE800EV2 receiver, page 18
B308 Octo-output Module, page 20
Installation Guide
Installation workflow | en
2017.10 | 03 | F.01U.298.026
13