Siemens Sinumerik 840C Diagnostics Manual page 57

04/96
3026 Fixed-text component too large
S
Scan
On display selection via softkey
S
Effect
Not all fixed texts are displayed
Explanation
The programmed fixed text part in the display description is too large.
Remedy
Using the NC workstation, reduce the fixed text part of the display or split up the contents over several displays.
3027 Graphics section too large
S
Scan
On display selection
S
Effect
No graphics display
Explanation
The programmed graphics part in the display description is too large
(max. 4 Kbytes).
Remedy
Using the NC workstation, reduce the fixed text part of the display or split up the contents over several displays.
3029 Window beyond configuring area
S
Scan
On display selection
Effect
Display build-up is aborted when the window of a display being configured is outside the configuring area.
Explanation
Additional subdisplays can be configured in a screen. The subdisplay windows can be moved in the configuring
area. As a result the window may have been moved outside the configuring area → configuring error.
Remedy
Configure the window movement so that it does not leave the configuring area (see also alarm 3037).
3030 Cursor memory not available
S
Scan
On display selection
Effect
The display selected is treated as though there were no cursor memory.
Explanation
The cursor memory programmed in the selected display is incorrect (illegal number, or too large).
Remedy
Redefine cursor memory with NC workstation, since the cursor memory has the task, when a display is recalled,
of putting the cursor back where it was when the display was removed.
3031 Too many part programs
Scan
On display selection
Effect
Slower display build-up and processing time may result.
Explanation
The configuring engineer has called up too many display descriptions with part program parts
Remedy
Only incorporate a maximum of 5 part programs in the display descriptions if possible. The alarm need not be
acknowledged as it is only for information.
Note
Applies to SW 1 only
3031 Error: NCK softkey text to MMC
S
Scan
When selecting the menu
S
Effect
The softkey text is not displayed
Explanation
An error has occurred while transferring the softkey text from NCK to MMC.
Remedy
Activate notebook for I code and send message to
System support together with notebook entry (system program change required)
Note
Applies as from SW 2
3032 Variable component too large
S
Scan
When selecting a display with a softkey
S
Effect
None
Explanation
The programmed variable display part of the display description is too large.
S
Remedy
Check display with NC workstation, and if necessary regenerate
S
Reduce variable display part

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
Acknowledgement key
Acknowledgement key
Acknowledgement key
Acknowledgement key
Acknowledgement key
Acknowledgement key
1–49