Siemens Sinumerik 840C Diagnostics Manual page 135

04/96
120024 Error in data/part program ...
Scan
The error occurred while transferring the file.
Effect
File has not been transferred or only partially.
Explanation
Syntax error in file structure.
E.g.: % MPF in part program on MMC
Remedy
Correct the file
120025 Error during job processing
Scan
Error occurred while transferring the above file.
Effect
File has not been transferred or only partially.
Explanation
Check selected files
Remedy
Restart transmission
120026 Only possible in Reset
Scan
The error occurred while transferring the above file.
Effect
File was not transferred or only incompletely.
Explanation
The selected data can be transferred in RESET mode only.
Remedy
Trigger NC Reset and transfer; start again.
Note
Applies as from SW 4.4
120027 Error in file structure
Scan
The error occurred while transferring the above file.
Effect
File was not transferred or only incompletely.
Explanation
Syntax error in the file structure. Data after end of list. An item of data follows M02.
Remedy
Make the corrections in the file.
Note
Applies as from SW 4.4
120028 Cycle disable set
Scan
The error occurred while a file was being transferred.
Effect
File has not been transferred or only partially.
Explanation
The cycle disable can be set for several cycles.
Remedy
Remove cycle disable for the cycles concerned.
120029 No communication to NCK
Scan
See alarm 110113
Effect
Explanation
Remedy
120030 Option not available
Scan
When activating the PG function
Effect
S5 package for programming functions cannot be called up.
Explanation
None
Remedy
Activate option

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
1–127