Siemens Sinumerik 840C Diagnostics Manual page 181

04/96
165041 Only possible in general reset mode
Scan
Softkey "Configure memory"
Effect
Function is not performed
Explanation
To configure memory, the control must be in the general reset mode.
Remedy
Activate the general reset mode under "Diagnosis/start-up"
Note
Applies as from SW 4
165042 Configuration not complete
Scan
Softkey "Configure memory", check DRAM and SRAM configuration
Effect
Function is not performed
Explanation
Not all data belonging to the configuration are available
Remedy
First enter all data
Note
Applies as from SW 4
165043 Insufficient memory space
Scan
Softkey "Configure memory", check DRAM and SRAM configuration
Effect
Function is not performed
Explanation
The calculated free memory space available is negative
Remedy
Change the configuration such that the remaining memory is positive
Note
Applies as from SW 4
165044 Controller data have not been calculated
Scan
Loading of standard drive machine data and also softkey "Calculate controller data"
Effect
Invalid data in the drive
Explanation
–
Remedy
Repeat action
Note
Applies as from SW 4
165045 No power section selected
Scan
Softkey "OK" in the drive machine data/selection module screen
Effect
Key is ignored
Explanation
Line with intermediate heading has been selected accidently. These lines serve only for the headings in the selec-
tion list.
Remedy
Select the correct module and press the key again.
Note
Applies as from SW 4
165046 No input authorization
Scan
Insert from clipboard, drive selection
Effect
Function is not performed
Explanation
The data block just edited cannot be modified even if password is set (e.g. standard data block)
Remedy
Select another data block
Note
Applies as from SW 4

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
1–173