Siemens Sinumerik 840C Diagnostics Manual page 42

1 Alarms
1.5.1 Alarm description
2069 5D tool length comp. not possible
Scan
When executing a part program
S
Effect
Machining is interrupted or not performed
S
Interlocking of NC START
S
Explanation
Cutter radius compensation has been selected
S
No linear interpolation has been selected
S
Function is not enabled
S
Machine data have been entered incorrectly
S
Export version
S
Remedy
Check program
S
Check machine data
Note
Alarm is displayed with reference to block and channel
2070 5D interpolation missing
Scan
When executing a part program
S
Effect
Machine stops
S
Interlocking of NC START
Explanation
More than three axes have been programmed in one block in a program, or a function has been selected which
may result in additional axes from the programming, e.g. when specifying the coordinate rotation.
S
Remedy
Check program
S
Have function option retrofitted if possible
Note
Alarm is displayed with reference to block and channel
2072 Wrong input value contour definition
Scan
When working in AUTOMATIC or MDA
S
Effect
Machining is not performed or is terminated
S
Interlocking of NC START
Explanation
When programming, an input which cannot be calculated was specified for contour definition calculation.
S
Remedy
Check program and correct input values
S
Cancel alarm using "RESET"
Note
Alarm is displayed with reference to block and channel
2073 No intersection contour definition
Scan
When working in AUTOMATIC
S
Effect
Machining is not performed or is terminated
S
Interlocking of NC START
Explanation
In calculating the contour definition with the programmed values, no intersection results.
S
Remedy
Check program settings
S
Cancel alarm using "RESET"
Note
Alarm is displayed with reference to block and channel
2074 Wrong angle value contour definition
Scan
When working in AUTOMATIC or MDA
S
Effect
Interlocking of NC START
S
Machining stops
S
Explanation
Angle > or = 360 degrees has been programmed
S
Value of angle for the contour described is meaningless
S
Remedy
Check and correct program settings
S
Cancel alarm using "RESET"
Note
Alarm is displayed with reference to block and channel
1–34

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
07/97
Reset key
Reset key
Reset key
Reset key
Reset key