Siemens Sinumerik 840C Diagnostics Manual page 120

1 Alarms
1.5.1 Alarm description
110018 Interface ... not initialized
Scan
DATA IN-OUT / DEVICES / SELECTION
Effect
Data transfer not possible
Explanation
Interface incorrect or not parameterized
Remedy
Select suitable interface file and reparameterize. If floppy selected, floppy drive must be connected to interface.
110019 Observe error log
Scan
DATA IN-OUT / (INPUT OR OUTPUT)
Effect
–
Explanation
Errors occurred during data transfer. The data concerned are listed in the logs and must be checked.
Cause: Data already exist, overwriting not desired.
No read/write authorization when reading in again, incorrect punch tape format
Remedy
Rectify the cause (if possible) and read in again
110020 Floppy is not formatted
Scan
DATA IN-OUT / (INPUT OR OUTPUT) / START
(INSERT NEXT DISKETTE) OK
Effect
Data are not read in/written
Explanation
The floppy is either not formatted or incorrectly formatted
Remedy
Insert formatted diskette
110021 Error on reading the archive
Scan
DATA IN-OUT / DATA INPUT / START
Effect
Data are not read
Explanation
Archive file is faulty
Remedy
–
110022 No workpiece selected
Scan
LOAD NC / SHOPFLOOR SHEET
Effect
No display
Explanation
Selected data are not workpieces
Remedy
Select workpiece under LOCAL or GLOBAL
110023 There are no comments for ...
Scan
LOAD NC / SHOPFLOOR SHEET / COMMENT
Effect
–
Explanation
No comment available for current workpiece
Remedy
Enter comment in program
110024 Archive list/job list is empty
Scan
DATA IN-OUT / DATA OUTPUT / ARCHIVE LIST
Effect
No data are being read out
Explanation
No object in the archive list can be accessed
Remedy
Check archive list
1–112

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey