Service Displays - Siemens SINUMERIK 840Di sl Operating Manual

8
Diagnostics operating area
8.4

Service displays

8.4

Service displays

:
Service Overview
Green:
Yellow:
Gray:
Red:
Line:
Special characters: Error when reading the data, e.g., if date not available.
8-396
Function
When commissioning digital drives and diagnosing faults, the various
operating states of individual machine axes can be visualized with a
type of traffic light indicator in the "Service overview" display, which
you can open from the "Service display" menu.
This overview shows specific enable signals and statuses for each of
the available axes 1 to 31. Up to 6 different states can occur on each
axis:
Columns for machine axes 1 to 31
Differentiating features of the traffic light indicator for each axis:
The axis is behaving normally.
The axis is not ready.
The axis is not affected.
An alarm is pending for this axis.
No drive assigned to axis.
Rows with the drive diagnostic functions
Drive enable (terminal 64/63)
Pulse enable (terminal 64/48)
Pulse enable (term. 663 / SI: drive relay)
Setup mode (terminal 112)
PLC pulse enable
Speed controller enable NC
DC link status
Enable pulses
Drive ready
Heatsink temperature warning
Power section in i2t limitation
Motor temperature warning
Measuring system 1 active
Measuring system 2 active
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
8
01/2008
© Siemens AG 2008 All rights reserved.