Using The Simulation Function - Siemens SINUMERIK 840Di sl Operating Manual

6
"Program" operating area
6.8 Program simulation

6.8.1 Using the simulation function

Main menu
Horizontal main menu
End
simulation
Loaded Match
or
data data
Timing
Search run
6-316
Sequence of operations
After a program or workpiece is selected, the Simulation softkey is
made available.
Turning technology main screen
When you select a simulation via a workpiece, first the machining list
from the Channel/spindle menu (see below) is displayed. Press OK to
exit the menus. The main menu is now displayed.
Terminate simulation. Return to the program overview or ASCII editor.
You need the correct password for this.
With the correct password you can match the simulation data with the
corresponding "NC active data" (setup data, tool data, machine data,
cycles).
See "Match data" menu
Tabular evaluation of the execution times for the current simulation
session (see Chapter "Downtime settings")
The function "Search run" can be used to start the simulation
selectively for specific sections.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
6
01/2008
© Siemens AG 2008 All rights reserved.