Jog Data - Siemens SINUMERIK 840Di sl Operating Manual

5
01/2008

5.5.2 JOG data

G function
JOG feedrate
Continuous JOG
Variable increment
JOG spindle speed
Spindle
Setting
data
JOG
data
Edit spindle data
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Function
The feedrates must be specified in the unit determined by the G
function.
G94 Feedrate in mm (inch)/min
G95 Revolutional feedrate in mm (inch)/rev
Feedrate value in the JOG mode
• JOG mode:
The axis moves as long as the key is pressed.
• Continuous
The axis begins to move when the key is pressed
mode:
once and continues until:
− The key is pressed again.
− NC Stop.
− Reset.
− Software/hardware limit switch.
Increment value for JOG variable increment
The following data are displayed only if a spindle is configured:
Spindle speed in JOG mode
JOG data for the master spindle:
• Spindle no.:
Name of leading spindle
• Direction of
Direction of rotation of leading spindle
rotation:
Speed of the master spindle in JOG mode
• Spindle speed:
Sequence of operations
Press the "Setting data" softkey.
The vertical softkey bar changes.
Press the "JOG data" softkey.
The "JOG data" window is opened.
Position the cursor bar on the appropriate input field and enter a new
value.
or:
Select a new value using the <SELECT> key.
Parameters operating area
5.5 Setting data
5
5-223