Siemens SINUMERIK 840Di sl Operating Manual page 215

5
01/2008
Prerequisite
I.
Filter selection
Filter 1-6
Magazine
selection
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Sequence of operations
Select the tool management
"Filter lists" softkey
The screen provides up to 6 filters for selection by softkey, depending
on the configuration in paramtm.ini.
Vertical softkeys
The softkey label "Filter 1- 6" is an example of how a label can be
configured to represent the 6 filters that are permitted. Pressing the
softkey starts determining the tools that match the criteria in the NC
and jumps to a 2nd screen that displays the hit list. The filter
produces a snapshot of the data. This data is not updated later.
You can use the filter definition to specify whether the filter always
applies to the whole TOA or is restricted only to single magazines.
You can use the "Magazine selection" softkey to select a particular
magazine or "All magazines" for a restrictable filter.
When you switch from a magazine list to the filter lists and no current
filter or batch processing is active in the TOA (you access the first
screen "Filter selection"), the current magazine in the magazine list is
taken as the preset value for restrictable filters.
If the situation is the same when coming from the tool list, the preset
value is "All magazines".
Parameters operating area
5.3 Tool management
5
5-215