Siemens SINUMERIK 840Di sl Operating Manual page 190

5
Parameters operating area
5.3 Tool management
(Names assigned by
user)
W. offset
list 1
W. offset
list 2
W. offset
list 3
Tool data
Find
D number
Current
D number
5-190
Note
The data you enter are always updated immediately (without
prompting). You can edit the properties of the new tool by pressing the
"Tool details" softkey.
It is not possible to edit the data directly in the table.
You can only edit the name and type of a tool by selecting Create
New, not via Tool details.
To change a name, you have to create a new tool and delete the old
one.
Vertical softkeys (working offset list)
Selection of a table structure configured by the user
(if configured), e.g.:
• General data
• Geometry data
• Wear data
You can display and edit the complete data of a tool (as in the
magazine list).
Find an entry with a specific D number/DL number.
• Enter the D number and DL number you want to find in the search
window.
• Confirm with "OK". If a matching entry is found, the cursor jumps to
the corresponding line. If you have not specified a DL number, the
cursor is positioned on the first line of the matching tool.
The D number of the current tool is determined and displayed.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
5
01/2008
© Siemens AG 2008 All rights reserved.