Siemens SINUMERIK 840Di sl Operating Manual page 243

5
01/2008
Manage
data
New
References
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Data is only saved for variable definition files, not for macros.
Additional information
If there is insufficient memory space available to activate the definition
file, then the file must be unloaded. After the memory size has been
adjusted, the file must be loaded from the NC to the HMI and back
again to the NC. The files are then activated.
Create a definitions directory
The definition files that the user can access are created and edited
under the definitions directory _N_DEF_DIR:
• SACCESS.DEF (_N_SACCESS_DEF)
• MACCESS.DEF (_N_MACCESS_DEF)
• UACCESS.DEF (_N_UACCESS_DEF)
They do not need to be activated but are loaded to the passive file
system of the NCK as follows:
Press the "Manage data" softkey.
The horizontal and vertical softkey bars change.
Load the definitions directory in the HMI without modifying the existing
access authorization.
Change write access
The data imported during the series commissioning are created and
edited in the definitions directory _N_DEF_DIR:
• SACCESS.DEF (_N_SACCESS_DEF)
• MACCESS.DEF (_N_MACCESS_DEF)
• UACCESS.DEF (_N_UACCESS_DEF)
They do not need to be activated but are loaded to the passive file
system of the NCK as follows:
Definition and creation of user data
See /PGA/, Programming Guide Advanced
Parameters operating area
5.7 Define user data
5
5-243