Siemens SINUMERIK 840Di sl Operating Manual page 234

5
Parameters operating area
5.6 Zero/work offset
Basic WO
Settable
WO
Active WO
+ offset
Axes +
Axes -
Rotation
Offsets
scl., mirr.
Change
active WO
5-234
All defined basic work offsets (global and channel-specific) are
displayed in a table.
The display mode can be changed by softkey (see above).
You can edit the values directly in the table.
Rotations are not possible with global frames, since no geometrical
relationship exists between the axes in this case.
All defined settable work offsets are displayed in a table and can be
edited if necessary (select and edit).
Additional information
• Changes to the work offsets are updated immediately on input.
The entries no longer have to be confirmed separately.
• If not all work offsets are displayed in the tables, you can scroll
through the table with the corresponding keys.
Display and edit the active work offset
Press the "Active WO + offset" horizontal softkey.
The vertical softkey bar changes.
Displays the active work offset of the next axis.
Displays the active work offset of the previous axis.
You can use these softkeys to change the display mode of the
currently displayed work offsets.
A table of currently active work offsets and the offsets of the selected
axis are displayed. You can select and, if necessary, edit the
individual values in the table.
The following values are displayed:
• Global basic WO; Coarse and fine (if defined)
• Channel-specific basic WO; Coarse and fine (if defined)
• Settable WO; Coarse and fine (G57)
• Programmable WO; G58 (TRANS), G59 (ATRANS)
• T number and D number of active tool
• G17 (geometry, wear, base).
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
5
01/2008
© Siemens AG 2008 All rights reserved.