Maintenance Part List - Toshiba e-STUDIO206L Service Manual

7.10 Maintenance Part List

The parts used for the maintenance of this equipment are as follows.
No. Item
1 Door switch jig
2 Brush
3 Doctor sleeve jig
4 Developer material nozzle
5 Wire holder jig
6 Belt tension jig
7 High-voltage transformer jig
8 Downloading jig (DLM board)
9 Download JIG-2 (6 Flash ROMs)
10 ROM writer adapter (For 1881)
11 ROM writer adapter (For 1931)
12 Drum bag
13 ROM
14 Harness jig
15 Patting powder
16 Color test chart (TCC-2)
17 Color test chart (TCC-3)
18 Fuser unit fuse
* "P-I" represents the page item in "e-STUDIO206L/256/306/356/456/506 Service Parts List" or "e-
STUDIO207L/257/307/357/457/507 Service Parts List".
No.1-13, 15-17: Refer to "e-STUDIO206L/256/306/356/456/506 Service Parts List" or e-
STUDIO207L/257/307/357/457/507.
No.14: Refer to "MJ-1101 Service Parts List" or "MJ-1107 Service Parts List".
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Purpose
Used to adjust high-voltage
transformer.
Cleaning inside of the equipment
Measuring the gap between the
development sleeve and the doctor
blade
Pouring the developer material
(attached to the developer bottle)
Fixing the wire at the assembly of the
carriage wire
Adjusting the belt tension at the
installation of the scan motor
Used to adjust high-voltage
transformer.
Updating the scanner/options ROM
Updating the system/engine ROM
Writing the data of PWA-DWNLD-
350-JIG2
Writing the data of PWA-DWNLD-
350-JIG2
Storing the drum
Installing the DLM board
Updating the converter PC board
For photoconductive drum
For test print (A4/LT)
For test print (A3/LD)
For fuser unit
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
7 - 51
Parts list
<P-I>
e-STUDIO e-STUDIO
206L/256/ 207L/257/
306/356/ 307/357/
456/506 457/507
101-1 101-1
101-2 101-2
101-3 101-3
- -
101-5 101-5
101-6 101-6
101-7 101-7
102-1 102-1
102-2 102-2
102-4 102-4
102-5 102-5
102-21 102-21
102-6 102-6
21-3 21-3
101-17 101-17
101-22 101-22
101-23 101-23
101-18 101-18
PREVENTIVE MAINTENANCE (PM)
7