Commissioning The Camera With Heater Option Fitted - Bosch MIC612 Operation Manual

28 en | Install the MIC (standard) PSU
Figure 5.10: Position of LEDs - MIC Series IR power supply PCB
Number LED
1
2
3
4
5
6
30. Re-attach the enclosure lid and tighten the four (4) captive screws on the cover to ensure
that the enclosure is watertight.
5.10

Commissioning the Camera with Heater Option Fitted

To enable the heaters, you must change two links on the printed circuit board (PCB) of the
power supply. Follow these steps:
1.
2.
2016.03 | 2.2 | F.01U.249.416
Description
LED 1 Indicates that 18 VAC is available from the power supply and that the
LED 2 supply fuses are intact.
LED 3 Illuminates when the washer drive is on.
LED 4 Monitors the internally generate +5 V.
LED 5 Illuminates when the IR lamp supply is turned on by the camera
telemetry.
LED 6 Status LED. Pulses On/Off when Multi Alarm is selected.
LED 7-10 Illuminate when the associated alarm is active.
Disconnect the power supply from the power source.
Locate Link 1 and Link 2 on the PCB, next to terminal block HD6. The default setting is
0V.
Operation Manual
MIC612 Thermal Camera
Bosch Security Systems