Active Commands In Fastaddress; Setting Passwords; Special Passwords; Setting Passwords, Bosch Protocol - Bosch MIC612 Operation Manual

MIC612 Thermal Camera
To set FastAddress with a Pelco Keyboard:
1.
2.
3.
4.
5.
6.
7.
8.
9.
7.7

Active Commands in FastAddress

The table below identifies the commands that will work and those that will not when users
send commands via the FastAddress of the thermal camera:
Commands that will work
Pan, tilt
Thermal camera commands
Certain Aux commands (list to
be populated)
7.8

Setting Passwords

Passwords are used to control access to locked command menus. Unlocked commands are
available to all users. Passwords are four (4) digits in length.
7.8.1

Special Passwords

The table below identifies special passwords and their function and security level.
Password
0000 (default)
9999
7.8.2

Setting Passwords, Bosch Protocol

To set or change a password (locked command):
1.
2.
3.
4.
Bosch Security Systems
Press and hold 95-PRESET for two seconds to open the Pelco Setup menu.
Move the joystick to select the Command Lock menu.
Press the FOCUS or the IRIS button to turn Command Lock to OFF.
Move to the FastAddress menu and press the FOCUS button or the IRIS button to open
the menu.
Use the joystick to enter the unique identifier for the camera.
Move the joystick up or down to select the number.
Move the joystick right to move to the next number position.
Move the joystick right to select Continue. Then, press the FOCUS or the IRIS button.
Use the keyboard to enter the FastAddress number. Then, press the Camera button.
Note: To use a FastAddress number that is already assigned to a different camera, you
must clear the number first.
Move the joystick down then up again to set the FastAddress number.
Press the FOCUS or the IRIS button to store the FastAddress number. The on-screen
display menu confirms that the camera stored the FastAddress number.
Function / Security Level
Enables security and requires a user to enter the unlock command
OFF-90-ENTER before invoking a locked command.
Disables all security and allows all users to access locked
commands.
Press OFF-90-ENTER to turn off the command lock.
Press SET-802-ENTER to access the password menu.
Tilt the joystick up or down to choose a number. Tilt the joystick right to move to the next
number position.
Follow the on-screen instructions and save the password. You receive an on-screen
confirmation.
Commands that will not work
Menu commands
Visible camera commands
Certain Aux commands
Operation Manual
Getting Started | en 37
2016.03 | 2.2 | F.01U.249.416