Bosch MIC612 Operation Manual page 23

MIC612 Thermal Camera
Figure 5.8: MIC PSU Enclosure, with cable glands identified
Number
1
2
3
4
18. Connect the shielded composite cable to terminal block HD3 (and, if necessary, HD6 and
HD7) following the color coding as shown in the figure below, and printed on the PCB.
No ID, Connection/
. Terminal + Pin
1 HD3-1
2 HD3-2
3 HD3-3
4 HD3-4
5 HD3-5
6 HD3-6
7 HD3-7
8 HD3-8
9 HD3-9
10 HD3-10
11 HD3-11
Bosch Security Systems
Description
Optical Video out
Composite cable
Optional switched video output
Head-end / Telemetry controls
PCB Mark, Description/Function of Connection
Signal
Power Low Voltage Power (Input 1) / AC supply
Power Low Voltage Power (Input 2) / AC supply return
RxB Telemetry I/O to RS-422/485 [Rx +]
Full Duplex RxB/Half Duplex Tx/RxB
RxA Telemetry I/O to RS-422/485 [Rx -] Full Duplex
0v
TxA Telemetry I/O to RS-422/485 [Tx -] Full Duplex
TxB Telemetry I/O to RS-422/485 [Tx +] Full Duplex
Video Video output of optical camera to Control Room
Video 0V Video signal return (optical camera) (ground to
Control Room) (Coax - BNC CN1)
Tamp Sw
Wash [Optional] Washer Drive Signal
RxA/Half Duplex Tx/RxA
Ground [Drain Wire / Shield]
TxA
TxB
(Coax - BNC CN1)
[Optional] Tamper Switch
Operation Manual
Install the MIC (standard) PSU | en
Cable Gland Size
M12
M16
M12
M12
PCB Mark,
Cable Color
Red
Green
White
Yellow
Screen (Black)
Blue
Violet
Core
Screen
Black
Orange
2016.03 | 2.2 | F.01U.249.416
23