Panel Description; Front Panel - microHAM micro2R u2R User Manual

(1) MIC: Microphone input (headset microphone).
Connector: 3.5mm (1/8") stereo
TIP – Signal (bias)
(2) LATCH: Indicates when "latch" mode is selected.
Toggle status by a short press of the Latch/Mix button.
(3) MIX: Indicates when audio mixing is selected.
Toggle status by a long press of the Latch/Mix button.
(4) RX R1: Receiver 1 active.
(5) RX AUTO: Receiver selection is controlled by logging program or follows transmitter selection.
(6) RX R2: Receiver 2 active.
(7) TX R1: Transmitter 1 active.
(8) TX AUTO: Transmitter selection is controlled by logging program.
(9) TX R2: Transmitter 2 active.
(10) PTT R1: Indicates Radio 1 PTT is active.
(11) PTT R2: Indicates Radio 2 PTT is active.
(12) FSK: Blinks with FSK output.
(13) PHONES: Output for operator headphones.
Connector: 6.3mm (1/4") stereo
TIP – Left
(14) MIX: Controls the level of mixing between the left and right headphone channels.
(15) LATCH: Tap to toggle "Latch" status, Hold to toggle "Mix."
microHAM © 2010 All rights reserved

3 - PANEL DESCRIPTION

Front Panel

RING – NC (bias)
RING – Right
6
SHELL – Shield
SHELL – Common