Menu: Help; Device Configuration - microHAM Digi Keyer II Instruction Manual

Manuals: Link to microHAM manuals located on your system.
Setup Guides: Link to software configuration guides for many common applications.
Cable Schematics: Link to cable diagrams.
Download Documents: Downloads microHAM documentation including updated manuals and setup
guides. You may specify the products for which you want documentation.
NOTE: Download Documents requires an Internet connection.
microHAM Home Page: Link to
microHAM Downloads Page: Link to
Show Tooltips: When checked, small, single line help is displayed below the mouse cursor.
Update Router: Download and install the most recent version of Router.
About: Shows the Router's internal version number
Change logs: Shows the Router and firmware changes.
There are nine (9) tabs for configuring DIGI KEYER II. Each tab controls a part of the device functions. Any
change is applied immediately to DIGI KEYER II. Changes in Messages are NOT applied automatically. To
store them use buttons Store or Store All.
Ports - used to assign virtual ports to the DIGI KEYER II for use by applications.
Audio - used to configure on-off keying decoders (Q-CW/P-FSK) and CW side tone.
Audio Mixer – duplicates the Windows Mixer for DK II in Windows XP and 2000 only.
PTT – used to configure PTT outputs, timing and sequencer.
CW / WinKey – controls WinKey settings.
CW & FSK Messages – used to store and edit CW or FSK messages.
Keyboard - used to configure the optional PS/2 keyboard or Keypad.
System Settings – used to configure the optional Auxiliary CI-V output.
microHAM © 2010 All rights reserved
HELP MENU
www.microHAM.com
www.microham.com/contents/en-us/d29.html
DEVICE CONFIGURATION TABS
17