Ports Tab - microHAM Digi Keyer II Instruction Manual

Once the virtual ports have been created they must be associated with a specific device channel (e.g.,
Control, CW, PTT, etc.). These assignments should correspond to settings of the application software and
must be configured first in Router then in the application (e.g., logging program, MMTTY, MixW, etc.).
Proper configuration of the port assignments in this tab is critical for integration with logging and
digital mode softwre. Read the following information carefully.
DIGI KEYER II has eleven functions with indication of the state and settings applied by the host application
CAT (uses RxD and TxD)
●
nd
2 CAT (virtual "fork" for the main CAT channel)
●
FSK (uses TxD and optionally RTS/DTR for PTT)
●
nd
2 FSK (uses TxD and optionally RTS/DTR for PTT)
●
CW (uses DTR or RTS)
●
PTT (uses DTR or RTS)
●
nd
2 PTT (uses DTR or RTS)
●
Foot Switch (uses CTS, DCD, DSR or RING)
●
Squelch (uses CTS, DCD, DSR or RING)
●
WinKey (uses RxD and TxD)
●
Control (uses RxD and TxD)
●
General note: Do not assign virtual ports to those functions which are not used by the application. It is
unnecessary and only consumes resources.
microHAM © 2010 All rights reserved

Ports Tab

18