microHAM Digi Keyer II Instruction Manual page 36

NOTE: For the Elecraft K3 and other transceivers that have a separate "line In" control, do not
adjust the TX WAVE slider. Instead, adjust the Line In level until the ALC shows the correct level.
7. Set the RX RECORDING/DIGIAL sliders to approximately 80% and adjust receive audio levels with the
RX MAIN and RX SUB controls on the front panel of DIGI KEYER II.
8. You may want to store these Router settings to the last preset. Click Preset | Save as, choose position
number 12, name it Default and store settings.
TIP: When you start to create your own presets, always begin by selecting the "default" preset.
This will configure the audio levels to the proper state before starting any customization.
Setting audio levels in Vista and Windows 7:
Because Vista and Windows 7 do not allow one application to set the overall (master) audio levels it is
necessary to set up the sound card levels using the Windows Sound Control Panel.
1. On Router's Audio tab, click the "Sound Card" button.
2. On the "Audio Devices" window, select "Headset Earphone (microHAM CODEC)" in the Mixer and
WaveOut boxes.
NOTE: You may need the WaveOut and WaveIn indexes of the sound card to configure some
programs. Make note of them or remember where you can find the "Sound Card ID" numbers.
microHAM © 2010 All rights reserved
36