Audio Tab - microHAM Digi Keyer II Instruction Manual

The Control Protocol Monitor should not be needed under normal conditions. However, if there are
problems with a particular logger, it may be useful to Start a capture and close the window. When a
problem is noticed, the window can be opened and the Control protocol log Saved for analysis.
The monitor log is circular – only the last 20 kilobytes or so will be saved in order to prevent creating
very large files.
In addition to providing for basic "Line Out" audio for digital mode operations, DIGI KEYER II has expanded
capabilities to support the microHAM micro2R two radio controller and the special on/off keying modes
(p-FSK and q-CW) of fldigi by W1HKJ. These enhanced capabilities are controlled from the Audio tab.
Use Q-CW: connects the right channel tone decoder to the CW output to
allow audio tones to be used for "hard keyed" CW. This permits
CW decoding software that only generates audio output to be
used with the CW function in most rigs.
Use P-FSK: connects the right channel tone decoder to the FSK output.
This allows the on/off keyed tone generated by fldigi to be used
with the normal "RTTY" (FSK) mode of most rigs. .
Force LINE IN selection: (Windows XP Only) Disables the "u2R Mic" input (rear panel) when DIGI
KEYER II is not used with a microHAM micro2R.
Sound Card: is only visible with Windows Vista or Windows 7. It displays the Mixer ID, Wave In ID
and Wave Out ID for each input/output.
Side Tone:
DIGI KEYER II includes an internal piezeo speaker for sidetone. The sidetone
frequency is selectable from 338, 450, 675 and 1350 Hz. Sidetone can
be enabled for all CW output or only manual (paddle) input.
microHAM © 2010 All rights reserved

AUDIO TAB

26