microHAM Digi Keyer II Instruction Manual page 22

An initial indication of proper audio drive level can be seen on the ALC meter of the radio. Provided
that there is NO audio processing in circuit and that the microphone gain control is in its normal
operating position, then, if the ALC does not show or just starts to indicate during transmission, the
signal is likely to be clean. It is also important is to turn off the microphone compressor, ANY transmit
audio equalizer, AND transmit DSP when AFSK is used. DO NOT use any form of digital modulation
(sometimes called "Transmit DSP") with AFSK or PSK. Some transceivers bypass these circuits
automatically when signal is routed to the rear audio jack instead of the microphone jack, but some
do not (for example, the TS-850).
TIP: If your transceiver supports FSK use it for RTTY whenever possible. In many transceivers
RTTY (FSK) mode provides improved receiver filtering and is the only way to guarantee a clean
RTTY signal no matter how the microphone gain or compressor (processor) is set on your
transceiver.
When a COM port is assigned in Router but not in the application program (or the application is not
running), Router will indicate the channel is closed.
When an application opens the COM port,
Router will indicate the channel is open and
display baud rate, number of data bits, parity and
number of stop bits in use. For example, 45
5N1.5 means: 45 Baud, 5 data bits, no parity, 1.5 stop bits.
The second FSK port is useful when operating split with radios that have two receivers (e.g., FT-1000, FT-
2000, FT-9000, K3, Orion or IC-7800). The second instance of the RTTY program should specify "right
channel" for its audio source and should be configured to use the 2
Radios without a second receiver can use the 2
decoding algorithm to provide diversity decoding and transmit from either program.
TIP: If you see a baud rate other than 45.5 baud (e.g., 4800 or 9600), the application is NOT
configured correctly for FSK RTTY operation.
PTT: The virtual port used for FSK can also support PTT (required by MMTTY). When you use MMTTY,
select the PTT box and RTS will used for PTT. Do not use the FSK port for any other function.
Invert: Some transceivers lack the ability to set the sense of the FSK input. If you cannot set the proper
sense, check the invert box. This is normally necessary only with the TenTec Omni V, Omni VI and
Kenwood TS-940.
Strict bps: Some programs rely on the the FSK port for proper PTT timing; they drop PTT (unkey) when
the FSK port buffer is empty. With virtual ports, this may cause PTT to drop before the contents of a
message (macro) are complete. 'Strict bps' disables the virtual port buffering and transmits one character
at a time to the output. Due to the additional overhead, FSK output will be slightly slower but operation will
be more reliable.
To test FSK operation from the computer to the radio, click on Test button with no port assigned or the port
closed. The Test button will generate "RY" two times.
microHAM © 2010 All rights reserved
nd
FSK port for a second RTTY program with a different
22
Edited by Geoff Anderson, G3NPA
nd
FSK port for its FSK output.