Cw Messages Tab - microHAM Digi Keyer II Instruction Manual

On this tab you can define nine CW messages of up to 50 characters each which are stored in EEPROM.
Each memory may have a programmable repeat delay and/or call another memory.
Commands which may be included in a memory are:
Merge:
Cancel WPM:
Set WPM:
Set Key:
Set Wait:
Jump to:
Delay:
Test:
Store:
Store All:
Load from File: loads all messages from file
Save to File:
Messages can also be saved and replayed using an external keyboard or numeric keypad attached to the
PS/2 jack. See: External Keyboard.
NOTE: Messages are not saved or loaded with Presets
microHAM © 2010 All rights reserved

CW MESSAGES TAB

merge two characters without a letter space – [M]AS will sound AS .-...
restore speed set by the Speed pot.
force speed to the selected value regardless of position of speed knob.
close CW output for selected time in seconds.
wait selected seconds during playback.
used for looping a message or calling another message
sets the delay in seconds before looping or calling another message
plays a message without storing it
saves one message to DIGI KEYER II memory
saves all messages to DIGI KEYER II memory
saves all messages to file
32