microHAM MK2R Manual page 86

ACC output control: These commands control 16 bits represented by the 4-bit outputs of the ACC
●
port. The 4-bit outputs must be configured for "Protocol Control" on the ACC tab. Current firmware
treats the 4 four bits as a HEX representation (0-F) of a 1:16 decoder connected to the port. Only
one output may be active.
This command sets the output using a binary mask.
AM1xxxxxxxxxxxxxxxx<CR> SetAccOutputs(R1, outputs)
AM2xxxxxxxxxxxxxxxx<CR> SetAccOutputs(R2, outputs)
This command sets the output by decimal value.
AS1dd<CR> SetAccOutputSelection(R1, selection)
AS2dd<CR> SetAccOutputSelection(R2, selection)
Function control: This command selects Function 1 – 8
●
SAs<CR> ApplyScenario(scenarioIndex)
DVK, CW and FSK messages: These commands control playing and recording of messages. The
●
current operating mode (determined from the radio or Router if the radio is not CAT capable) will be
used to determine if Voice, CW or FSK messages will be played/recorded.
Abort::
This command aborts the current message and clears message queue.
MA<CR> AbortMessage()
Playback:
This command starts message playback – index is 1 to 9
MPm<CR> PlayMessage(msgIndex)
This command starts message playback in a loop – index is 1 to 9, interval is 0 to 9 seconds.
MPImi<CR> PlayMessagePeriodically(msgIndex, interval)
Record:
This command starts message recording – index is 1 to 9
MRm<CR> StartMessageRecording(msgIndex)
This command stops message recording.
MRS<CR> StopMessageRecording()
DVK Message Bank Select:
This command selects voice message bank – applies only to DVK.
MBname<CR> SetMessageBank(msgName)
microHAM © 2010 All rights reserved
86