microHAM MK2R Manual page 61

Hide thumbs Also See for MK2R:
Table of Contents

Advertisement

RADIO 1/RADIO2 ENABLE
Enable signal from MK2R to Radio1/Radio2 – delays generation of RF by radios equipped to use
the signal and provides "hot switch" free operation even with VOX or CAT T/R switching
RADIO 1 /RADIO2 INHIBIT IN
An external Inhibit input for devices such as Power Amplifiers that generate a "not ready" signal.
MK2R to delay the PTT1/PTT2 and Enable outputs until the external device signals it is ready.
RADIO 1 /RADIO2 PTT1 OUT
Copy of the microphone PTT – active only if PTT1 is enabled
RADIO 1 /RADIO2 PTT2 OUT
Copy of the rear panel PTT – active only if PTT2 is enabled
RADIO 1 /RADIO2 PA PTT
Copy of the PA PTT signal – active only if PA PTT is enabled
RADIO 1 /RADIO2 LNA PTT
Copy of the LNA PTT signal – active only if LNA PTT is enabled
RADIO 1 /RADIO2 TX FOCUS
High if the respective radio is selected for transmit.
RADIO 1 /RADIO2 RX FOCUS
High if the respective radio is selected for receive
STEREO FOCUS (SPLIT) OUT
High if stereo (split) headphone mode is selected
CW INPUT (Straight key)
Input for a second keyer – currently connected in parallel with LPT/Serial CW
RADIO 1 /RADIO2 BAND DATA OUTPUT
Band Data – 4 bit binary (defined in "Band Map") – indicating the band of the respective radio
RADIO 1 /RADIO2 BAND DATA INPUT
Band Data Input – 4 bit binary (Yaesu format) – from the respective radio
LPT pins 2, 7, 8, 9 COPY OUT
Copy of the data on pins 2-9 of the LPT input
BAND DATA – Active Radio
Band Data – 4 bit binary (defined in "Band Map") – indicating the band of the radio with transmit
focus
PROTOCOL CONTROLLED
Output controlled by logger using microHAM Control Protocol (e.g., logger controlled antenna
selection, "Band relay," or other logger specific data)
Serial Port 1 (Radio 1)/Serial Port 2 (Radio 2)
frequency related data generated within MK2R/MK2R+ – either Icom CI-V Transceive or SteppIR
protocol format – for controlling frequency dependent accessories like amplifiers, automatic
antenna tuners or SteppIR antennas.
microHAM © 2010 All rights reserved
61

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mk2r+Micro keyer 2r+Micro keyer 2r

Table of Contents