Installation; Preparing Mk2R For Use - microHAM MK2R Manual

Installing MK2R consists of several steps:
1) prepare MK2R to work with your radios
2) install microHAM USB Device Router (the control and interface software)
3) configure the Windows USB Audio Devices (MK2R+ Only)
4) configure Router
5) set audio levels
1. Turn off both radios and make MK2R rear panel accessible.
2. Plug the DB37M of one radio cable set into the RADIO1 connector on the rear panel of the MK2R.
Connect ALL connectors from the cable set to the matching jacks on the rear panel of RADIO1. Each
connector on the radio interface cable is marked same as the jack on your transceiver.
3. Plug the DB37M of the other radio cable set into the RADIO2 connector on the rear panel of the MK2R.
Connect ALL connectors from the cable set to the matching jacks on the rear panel of RADIO2. Each
connector on the radio interface cable is marked same as the jack on your transceiver.
RADIO1 should be your primary radio. Only the original station microphone for RADIO1 can
be connected to the MK2R rear panel mic jack (RJ-45). Using the wrong microphone can
damage the microphone, the radio or MK2R.
4. Connect cables from PTTIN1 to the PTT out of RADIO1 and from PTTIN2 to the PTT out of
RADIO 2.
Refer to the Operator's Manual for your transceiver for the proper signal connection. PTT output is
on the REMOTE DIN for Kenwood, the Band Data jack for Yaesu (or TXGND), and ACC2 (DIN 7) or
SEND for Icom. If your transceiver does not have an RCA connector for PTT output, it will be
necessary to make the proper adapter.
IMPORTANT: This connection is required for proper VOX operation.
5. Connect the microphone for RADIO1 to the RJ45 MIC jack. If your microphone has a Foster (round)
connector, use the adapter supplied with the RADIO1 cable set.
6. If your radios have two receivers (FT-1000D, FT-1000MP, FT-2000, FT-9000, Orion, IC-7800, K3, etc.)
connect the fixed level audio output from the second receiver to the SUB RX jacks of MK2R
7. Connect the supplied headphone cable to the MK2R R1+ R2 HP AUDIO jack and plug the 6.3mm (1/4")
plugs into the headphone jack of each radio.
8. Connect your paddles to the PADDLE jack.
9. If you use a foot switch, connect the foot switch for RADIO1 to FS1 and foot switch for RADIO2 to FS2.
If you use only a single foot switch, connect it to FS1. You will configure MK2R for single or dual foot
switch operation later with the MK2R control program.
microHAM © 2010 All rights reserved

4 - INSTALLATION

Preparing MK2R for Use

15