microHAM MK2R Manual page 78

std. key Numeric Keypad
NUM LOCK
NUM *
ESC NUM 0
F1-F9 NUM 1 – NUM 9
NUM DEL
NUM /
ALT
PG UP
NUM +
UP
PG DN
NUM -
DN
HOME
NUM ENTER
ENTER
ENTER
F10
CAPS LOCK
SPACE
|
0-9 a–z "#$%&'()*+,-./:;<=>?@\
0-9 A–Z !"$&='(),-./:;?
microHAM © 2010 All rights reserved
start/stop recording of message (recording mode is
indicated by NUM LED)
Tune (can be canceled by keys NUM 0 or ESC, or by the
paddle)
playback: stop transmitting (message or any characters in
buffer)
recording: abort recording without storing the message
playback: start message playback
recording: set message number
playback: periodically repeat last message (default interval
is 1 second, it can be changed by pressing the number on
number pad)
recording: no function
Switch between "speed control mode" and "serial number
mode" (serial number mode is indicated by SCROLL LED,
if present)
When held allows setting the serial number
WPM control Increase CW speed (step defined by configuration)
S/N mode Increment number by one without transmitting
WPM control Decrease CW speed (step defined by configuration)
S/N mode Decrement number by one
WPM control Reset CW speed to pot (knob) value
Transmit number with optional report and increase number
S/N mode
by one (format defined by configuration)
transmit CR and LF characters
Toggle PTT – alternative to foot switch
Switch between CW mode and FSK mode
(FSK mode is indicated by CAPS LED)
transmit space (if "type ahead" mode is active all buffered
characters are transmitted before this space)
transmit gap (one-half dit delay time), this character cannot
be recorded to a message from keyboard – it may only be
entered from Router
transmit character, if "CW type ahead" mode is active
character is pushed to type ahead buffer to be transmitted
after next space. Note: some special characters are
mapped to standard prosigns (see WinKey manual)
transmit character, if "FSK type ahead" mode is active
character is pushed to type ahead buffer to be transmitted
after next space
78
CW FSK Voice
mode mode mode